Removing the left air distribution flap motor (M21b)
NOTE:
TECHNICAL INFORMATION
The controller drive must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
The controller drive must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
Preliminary work
- Refer to ENTER THE INSTALLATION POSITION OF THE DAMPER MOTOR .
- Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
- Refer to VEHICLES WITH AIRBAG MODULE: REMOVING KNEE AIRBAG .
- Refer to REMOVING LEFT AIR DUCT .
NOTE:
For a better overview the removed condition is shown here.
- Disconnect plug connection (1).
- Loosen screws (2).
- Remove left air distribution flap motor (3).