Preparation for assembly:
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
Prepare plastic nozzle(s) for shaping adhesive bead (when not using the standard nozzle), can be cut to size during the air drying time.
Lay a test bead of approx. 50 mm - watch out for formation of bubbles/blisters when hot cementing; if OK, apply immediately to window glass.
- Interruption must be < 5 second (incorrect mixture ratio).
Cartridge must be vertical to window glass.
Black ceramic material impermeable to UV light is located on the peripheral zone of the inside edge of the window to protect the adhesive bead.
Glass ceramic material must not be damaged and must be treated as follows.