51 31... Instructions on gluing windscreen: Hardening:

WARNING: This page is about a different car, the 2002 BMW M Roadster, 2002 BMW M Coupe, 2001 BMW M Roadster, and 2001 BMW M Coupe. However, it is still accessible from the selected car via links, so may be relevant.

The adhesive hardens as it reacts with air humidity (with accelerator also due to mixed-in reaction paste) at room temperature.

Minimum hardening time (table) is obtained from 22°C and 38 % relative air humidity.

At ambient temperatures above 23°C and 50 % relative air humidity (hot countries), the adhesive open time is shortened to approx. 5 minutes (skin formation time).

The adhesive hardening process is interrupted completely at ambient temperatures below 5°C. In this event, there will be no increase in the strength of the adhesive bond.

Do not subject the vehicle to load on one side during the minimum hardening time (see table, without passenger AIRBAG), such as e.g.:

one wheel on kerb
lifting platform
etc.

Maneuvering inside garage/workshop:

only permitted on level ground
do not under any circumstance driver over access ramps, e.g. into multi-store car parks

Remove adhesive tapes after hardening time.

If you fail to adhere to the minimum hardening times (see table, without passenger AIRBAG):

leaks and wind noises will occur when the windscreen is moved