Removal & Installation: Starter: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2003 BMW M3, and 2002 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect starter motor pinion and ring gear for damage. If pinion or ring gear are damaged, replace as necessary.
- To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
- Replace and tighten screws of reinforcement plate to specification. See TORQUE SPECIFICATIONS . Then tighten down an additional 90 degrees with Torque Angle Measuring Dial (00 9 120). See SPECIAL TOOLS .