Activating Air Bag System (3.2CL & 3.5RL)

WARNING: This page does not describe the selected car, but rather 173 other vehicles, including the 2003 Volvo XC90, 2003 Volvo XC70, 2003 Volvo V70, 2003 Volvo V40, and 2003 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.

Ensure ignition is OFF and negative and positive battery cables are disconnected for at least 3 minutes. Connect 4-pin driver's air bag module connector to cable reel connector. Install access panel under steering wheel.
Connect 4-pin passenger's air bag module connector to SRS harness connector. Install glove box. Connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels. Connect driver's and passenger's side impact air bag module 2-pin connectors under seats.
Ensure ignition is off. Connect positive battery cable and then negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Before returning the vehicle to the customer, enter navigation and radio anti-theft codes, then enter the customer's radio station presets, and set the clock.

NOTE: On 3.5RL, Powertrain Control Module (PCM) idle characteristics must be reset after disconnecting battery.

Start and run engine at 3000 RPM with no loads and transmission in Park or Neutral. When radiator fan comes on, allow engine to idle for 5 minutes with A/C, headlights and rear defogger off.