Double Joint For Steering Spindle Lower Section (4WD): Installation
WARNING: This page does not describe the selected car, but rather 37 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2004 BMW 330xi, and 2004 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure.
- Clamping screw must rest in groove of steering spindle lower section (1). See Figure. Tighten to specification. See TORQUE SPECIFICATIONS .
- Replace clamping screw. It is only possible to join the steering spindle lower and upper sections in one position. See Figure. Tighten to specification. See TORQUE SPECIFICATIONS .
- Ensure steering gear is in straight ahead position. Clamping screw must rest in groove of steering shaft. See Figure. Tighten to specification. See TORQUE SPECIFICATIONS .