Drive Shaft Constant Velocity (CV) Joint Boot: Removal

WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 BMW Z8, 2000 BMW Z3, 2000 BMW X5, 2000 BMW M5, and 2000 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect CV joint. See DRIVE SHAFT CONSTANT VELOCITY (CV) JOINT . Using plastic hammer, drive out CV joint mounting bolts. See Figure . Remove washers. Remove end cover. See Figure .

CAUTION: Avoid damaging seal between CV joint and end cover.