Remove left and right output shaft

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the steps on the right and left side.

Remove output shaft

Release the cable for the wheel speed sensor from the holders (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the nut (1).
NOTE: Counter-hold at the Torx socket.
Detach the anti-roll bar link (2) from the spring strut.

Courtesy of BMW OF NORTH AMERICA, INC.
Turn swivel bearing outwards.
Set aside the anti-roll bar link (2).
Guide out the output shaft (1) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Secure component against falling.
Position the aluminum drift (2) on the output shaft (1).
Knock out the output shaft (1) from the front axle transmission with an aluminum mandrel (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the output shaft (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.