Partially installing the radiator for the high-temperature coolant circuit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in the radiator (1) of the high-temperature coolant circuit carefully
in the arrow direction.
- Feed the radiator (1) of the high-temperature coolant circuit in the lower area into the holder (2) in the arrow direction and install it.
- Bring the radiator (1) of the high-temperature coolant circuit up to contact surface in the arrow direction.
- Tighten down screw (1).
Radiator on holder Screw D6x20 tightening torque 6 Nm - Version with automatic transmission:
Feed in the transmission oil lines (1) at left and right on the brackets (2) and install.
If external radiators are installed: Connecting the coolant lines
NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly. - Check the sealing rings (1) of the coolant lines (2) for damage and replace them if necessary.
- Connect and lock coolant line (1).
The coolant line (1) must audibly engage.
- Connect and lock coolant line (1).
The coolant line (1) must audibly engage.
- Check sealing ring (1) of coolant line (2) for damage and, if necessary, replace it.NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly. - Connect and lock the coolant line (1).NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly. - Connect and lock the coolant line (1).
- Guide the air conditioning condenser (1) into the rubber mount (2) in the arrow direction and install it.
- Tighten down screw (1).
Air conditioning condenser holder on body Nut M6 tightening torque 8 Nm M6 screw tightening torque 8 Nm