Observing the hardening time of the screw locking agent on the screw plug

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
A hardening time of 24 h must be observed after wetting the screw with the screw locking agent.
During the hardening time, the engine must not be started.
Filling the coolant circuit is only permitted after the hardening time.

Observe the hardening time.
The high-temperature coolant circuit is not allowed to be filled during the hardening time.
Observe the hardening time.
It is not allowed to start the engine during the hardening time.

Courtesy of BMW OF NORTH AMERICA, INC.