Install accelerator pedal module
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Connect connectors (1) and lock.
- Feed the wiring harness into the holder (2).
NOTE:
RISK OF DAMAGE
Damage to wiring harness
During the assembly of the accelerator pedal module, make sure that the cable is not pinched between the holder and the accelerator pedal module .
Damage to wiring harness
During the assembly of the accelerator pedal module, make sure that the cable is not pinched between the holder and the accelerator pedal module .
- Damaged wiring harness must be replaced.
- First, insert the accelerator pedal module (1) at the top into the holder (2) in the arrow direction.
- Then, align in the mounting (3) at the bottom.
A positioning pin at the bottom of the accelerator pedal module helps ensure correct alignment.
- Replace the hexagon socket screw (1).
Parts: Hexagon socket screw
- Fit the hexagon socket screw (1) and tighten.TIGHTENING TORQUE SPECIFICATIONS
Accelerator pedal module to body M6 Replace screw. tightening torque 8 Nm - Clip in the cover.