Remove bearing bracket for pedal mechanism
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Vehicles without airbag module for driver and knee protection.
- Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
- Retract release tool 2 409 646 between brake pedal and brake booster.
- Apply support (1) of the release tool 2 409 646 on the bearing bracket. If necessary, position the support by rotating the screw on the release tool.
- Push release tool 2 409 646 in the direction of the arrow and lever out the brake pedal from brake booster.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Disconnect plug connection (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Unlock plug connection (1) and disconnect.
- Loosen nuts (1).
- Release screw (1) and remove bearing bracket (2).