Installing tie rod end
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Screw the tie rod end onto the tie rod up to the dimension (A), which was determined before removal.
If necessary, hold the track rod with an open-end spanner for counter support.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Tie rod end to tie rod | ||
| M10 | tightening torque | 32 Nm |
- Position the tie rod end (2) on the swivel bearing (3).
- Renew nut (1).
Parts: Nut
- Tighten nut (1). If necessary, counter support at the Torx socket.
TIGHTENING TORQUE SPECIFICATIONS
| Tie rod end to swivel bearing | ||
| M14 Renew nut. | Tightening torque | 165 Nm |
Follow-up work
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
- Refer to PERFORMING CHASSIS ALIGNMENT CHECK .