Adjusting camber (eccentric screw already renewed)
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Through the turning of the eccentric screws (setting of camber and track), the vehicle ride height can change. For the exact setting of the camber and track, the automatic ride height measurement should be activated in the wheel alignment equipment when available.
Through the turning of the eccentric screws (setting of camber and track), the vehicle ride height can change. For the exact setting of the camber and track, the automatic ride height measurement should be activated in the wheel alignment equipment when available.
NOTE:
TECHNICAL INFORMATION
In adjusting the track, the camber is also changed. The camber must therefore be adjusted first.
In adjusting the track, the camber is also changed. The camber must therefore be adjusted first.
NOTE:
TECHNICAL INFORMATION
Check the alignment of the active cruise control (ACC) after an adjustment on the rear axle that changes the driving axis.
Check the alignment of the active cruise control (ACC) after an adjustment on the rear axle that changes the driving axis.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Turn the eccentric screw (2) to set the camber to the target value.
- Tighten the nut (1) in the NORMAL POSITION .
NOTE:
Counter support the eccentric screw.
TIGHTENING TORQUE SPECIFICATIONS
| Camber control arm to wheel carrier | ||
| M14 Replace eccentric screw, eccentric washer and nut. | Tightening torque | 165 Nm |