Install the clutch slave cylinder

• Press cylinder together manually.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the hydraulic line (2) while it is pressed.
• Lock the clamp (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the special tool 0 491 256 (13 3 010) from the hydraulic line (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Hold the piston vertically downwards.
• Press the piston into the cylinder 5 times.

Courtesy of BMW OF NORTH AMERICA, INC.

• Press in piston until it engages.
• Clean the thrust piece (1) and the contact surface on the release lever.
• Slightly grease the thrust piece (1) on the contact surface (2).

  Grease, see ADDITIONAL INFORMATION .

Courtesy of BMW OF NORTH AMERICA, INC.

• Install clutch slave cylinder (2) with the holder (3).
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to VENTING CLUTCH HYDRAULIC SYSTEM .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .