Installing the connecting branches on the exhaust turbocharger for the cylinders 1 to 3

• Check the sealing ring (1) for damage, replace the connecting bracket (2) for cylinders 4 to 6 if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the sealing ring (1) for damage and replace the sealing ring (1) as needed.
• Wet sealing ring (1) with approved lubricant grease.
  INSTALLATION AID DESCRIPTION
  
  

  Lubricants G14

  900 ml, Can

  83232360412

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean the sealing surface (1) using special tool  0 495 102 (11 4 470)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in and install the connecting bracket (1) for cylinders 1 to 3.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Connecting brackets on exhaust turbocharger
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Connecting brackets on exhaust turbocharger
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the tank vent line (1).

  The tank vent line (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock connectors (1) and (2).

  The connectors (1) and (2) must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to FASTENING THE AUXILIARY COOLANT PUMP FOR THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 1 TO 3 .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .