Removing the engine from the installation position
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the combustion engine by turning the special tool 2 361 506 (00 6 103)
until it lies completely on the engine mounts.
- Feed out special tool 0 490 567 (11 0 020) on the special tool 2 459 012 and set aside.
- Feed out special tool 0 490 567 (11 0 020) on the engine mounting bracket (1) and set aside.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Remove the engine bridge (1) with a support person.
- Keep all the standard tools ready.
Number Description 1 Standard torque wrench 2 Swivelling extension 3 External Torx E14 - Tighten screw (1) of the left engine mount from the bottom using a standard tool.
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount to engine support bracket | ||
|---|---|---|
| M12 | tightening torque | 100 Nm |
- Release screw (1) of the right engine mount from the bottom using a standard tool.
TIGHTENING TORQUE SPECIFICATIONS
| Engine mount to engine support bracket | ||
|---|---|---|
| M12 | tightening torque | 100 Nm |
- Unscrew the bolts (1) of the special tool 2 459 012 .
- Feed out the special tool 2 459 012 at the cylinder head and remove.
Follow-up work
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING FUEL DELIVERY LINE .
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE FILLER CHANNEL OF THE WASHER SYSTEM .
- Refer to FASTENING THE WIRING HARNESS SECTION TO THE LEFT SHOCK TOWER .
- Refer to FASTENING THE WIRING HARNESS SECTION TO THE RIGHT SHOCK TOWER .
- Refer to INSTALLING THE COVER IN THE TOP RIGHT REAR PART OF THE ENGINE COMPARTMENT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE TOP REAR .
- Refer to INSTALLING THE SIDE HOOD SEAL .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .