Installing the trim strip for the exhaust turbocharger for the cylinders 4 to 6 on the cylinder head

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Check the trim strip (1) for damage, replace the trim strip (1) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Failure to comply with the regulations can lead to leaks and damage.

Guide in and position the trim strip (A) .
Replace screws (1) to (4) .
Parts: Screws

Fig 1: Trim Strip (A) Screws Tightening Sequence
Courtesy of BMW OF NORTH AMERICA, INC.
Join and tighten the screws in the order from (1) to (4) .

TIGHTENING TORQUE SPECIFICATIONS

Trim strip for exhaust turbocharger on cylinder head
M7X27 10.9 Observe tightening sequence! Replace screws.	1. Joining torque 2. Angle of rotation	20 Nm 90°
M7X27 10.9 Observe tightening sequence! Replace screws.	1. Joining torque 2. Angle of rotation	20 Nm 90°