Installing covers at front bottom on left an right sides

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the steps on the right and left side.

Installing bottom front cover from the side

Precondition

The front underbody protection has been removed.

Install the cover (1) .

Tighten screws (arrows).

TIGHTENING TORQUE SPECIFICATIONS

Lower side cover at front
Hexagon screw for thermoplastic	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.