Initializing the glass slide/tilt sunroof
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
The following prerequisites are the basis for a correct initialization and must be strictly observed.
The following prerequisites are the basis for a correct initialization and must be strictly observed.
- Press and hold the switch in the "vent position" direction.
The glass slide/tilt sunroof moves to the vent position.
- In the event of a delayed start or sudden stop of the glass slide/tilt sunroof, keep the switch pressed in the "vent position" direction.
- Continue to keep the switch pressed during the entire test module.
- After reaching vent position (A), continue to press and hold the switch for about 30 s.
The initialization starts:
- The glass slide/tilt sunroof moves from the vent position (A) in the direction of position (B).
- Screen (sliding headliner) fully closes.
- Screen (sliding headliner) fully opens.
- The glass slide/tilt sunroof moves to the "closed" position.
- The glass slide/tilt sunroof moves to the "open" position and immediately back to the "closed" position.
- After a brief pause, the screen fully closes.
The initialization is complete when the glass slide/tilt sunroof and the screen are completely closed.
- Release the switch.NOTE: TECHNICAL INFORMATION
If the switch is released in the meantime, repeat the initialization. Following successful initialization, the corresponding messages in the Check Control and the control display extinguish.- Carry out functional check (one-touch mode, anti-trapping protection and, if necessary, comfort function).