Securing the anti-roll bar link on the left and right to the anti-roll bar

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the steps on the right and left side.

Feed in and position the anti-roll bar link (2) on the left on the anti-roll bar (3) .
Replace nut (1) .
Parts: Nut
Tighten nut (1) .

NOTE: Counter-hold at the Torx socket.

TIGHTENING TORQUE SPECIFICATIONS

Front anti-roll bar link to anti-roll bar/spring strut
M10 Replace nut.	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and position the anti-roll bar link (2) on the right on the anti-roll bar (3) .
Replace nut (1) .
Parts: Nut
Tighten nut (1) .

NOTE: Counter-hold at the Torx socket.

TIGHTENING TORQUE SPECIFICATIONS

Front anti-roll bar link to anti-roll bar/spring strut
M10 Replace nut.	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Perform the steps on the right and left side.

Securing the anti-roll bar link to the anti-roll bar

Position the anti-roll bar link on the anti-roll bar.
Replace nut (1) .
Parts: Nut
Tighten nut (1) . If necessary, counter support at the Torx socket.

TIGHTENING TORQUE SPECIFICATIONS

Front anti-roll bar link to anti-roll bar/spring strut
M10 Replace nut.	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Perform the steps on the right and left side.

Securing the anti-roll bar link to the anti-roll bar

Position the anti-roll bar link on the anti-roll bar (2) .
Replace nut (1) .
Parts: Nut
Tighten nut (1) . If necessary, counter support at the Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Front anti-roll bar link to anti-roll bar/spring strut
M10 Replace nut.	tightening torque	56 Nm

NOTE: Perform the steps on the right and left side.

Fastening the anti-roll bar link to the anti-roll bar

Position the anti-roll bar link (4) on the anti-roll bar.
Protect the shock absorber from damage with a cloth (1) .
Replace nut (2) .
Parts: Nut
Tighten nut (2) . Counter support with a wrench (3) with Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Rear anti-roll bar link on anti-roll bar
M10 Replace nut.	Tightening torque	56 Nm