Secure the wishbone at the swivel bearing
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Deflection of the ball joint of the wishbone by more than 25°.
Damage to the bellows and premature wear in the ball joint.
Deflection of the ball joint of the wishbone by more than 25°.
Damage to the bellows and premature wear in the ball joint.
- The wishbone may be inclined by a maximum of 25° during installation or removal!
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
TECHNICAL INFORMATION
Otherwise, the rubber grommet can be damaged. The components must not be in contact.
Otherwise, the rubber grommet can be damaged. The components must not be in contact.
- Make sure that the rubber grommet (3) on the wishbone (1) is not damaged by the swivel bearing (2).
- Position the wishbone (2) on the swivel bearing (3).
- Replace nut (1).
Parts: Nut
- Tighten nut (1). If necessary, counter support at the Torx socket.TIGHTENING TORQUE SPECIFICATIONS
Wishbone to swivel bearing M14
Replace nut.tightening torque 175 Nm NOTE: Only perform the operation on the left side. - Attach the attachment rod (1) on to the ride height sensor (2).