Secure the juncture shaft in front on the front axle differential

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Clean all 4 threads (1) in the front axle differential flange before assembling the prop shaft.
Remove possible residues and contamination.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws.
Parts: Screws

Apply screw locking agent to all screw threads (1) before screwing.

CONSUMABLE SPECIFICATION

High-strength screw lock, Loctite 270

10 ml, Tube

83 19 2 210 337

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again.

Release special tool 2 413 317 .
Position the propeller shaft in front on the front axle differential.
Replace screws.

Courtesy of BMW OF NORTH AMERICA, INC.

Parts: Screws
Tighten screws (arrows).

TIGHTENING TORQUE SPECIFICATIONS

Prop shaft before the front axle differential
Replace screws. Joining torque and angle of rotation must be observed without fail.	Tightening torque	25 Nm
	Angle of rotation	45°