Reset ultra-small quantity adaptation
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
- Connect the diagnostic system to reset the minimum quantity adaptation:
- Read out vehicle data
- Identification without vehicle test
- Start vehicle test
- Vehicle handling
- Service functions
- Drive
- Engine electronics
- Adjustment programs
- Delete adaptations
- Reset adaptation values
- Reset ultra-small quantity adaptation