Remove the front output shafts (on the mobile lifting table)

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The figure shows the procedure for the front axle differential. The procedure for the bearing bracket is identical.

Loosen screws (1) .
Remove the swivel bearing mount (2) and set it aside.
Hold the swivel bearing (3) with the workshop crane 2 220 718.

Courtesy of BMW OF NORTH AMERICA, INC.
Release screw (1) on the output shaft (3) .
Tilt the swivel bearing (2) slightly forwards in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Secure component against falling.

Position the aluminum drift (2) on the output shaft (1) .
Knock out the output shaft (1) with the aluminum mandrel (2) and remove it from the front axle transmission.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide out the output shaft (1) in the arrow direction and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Install the stand (1) of the swivel bearing.
Tighten down screws (2) .

Courtesy of BMW OF NORTH AMERICA, INC.