Releasing camber control arm from the rear axle support

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Precondition

The coil spring is removed.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Release nut (1) .
Release the attachment rod (2) from the camber control arm.

Courtesy of BMW OF NORTH AMERICA, INC.
Release nut (1) .
Pull out the screw (2) .
Swivel the camber control arm (3) in a downwards direction and let it hang on the wheel carrier.

Courtesy of BMW OF NORTH AMERICA, INC.