Fastening the camber control arm on the rear axle support

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .

Swivel the camber control arm (3) to the top and position it on the rear axle support.
Replace the nut (1) and the screw (2) .
Parts: Nut, bolt
Insert the screw (2) and hand-tighten the nut (1) .
The screw connection is tightened with the torque wrench later in the NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
Position the attachment rod (2) on the camber control arm.
Replace nut (1) .
Parts: Nut
Tighten nut (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Attachment rod to wishbone/camber control arm
M6 Replace nut.	Tightening torque	8 Nm