Checking the underbody and all visible components

Check 

• Perform a visual inspection of the underbody.
  • Check for tightness (transmission, fuel system, brake components, steering).
  • Check for correct routing of the electrical wires (e.g. brake pad wear sensor).
  • Check for tightness (shock absorber).
  • Check installation of the extended springs and check for corrosion.
  • Check the underbody for damage.
  • Check all the attachments of the installed parts (e.g. undershields).

Result 

» Damage or leaks on the underbody.

Measure

• If necessary, remove the trim panels from underbody.

  Check holders, brake lines and fuel lines for damage and correct installation position.

Measure 

• Eliminate possible defects for a separate charge after discussion with the customer.