Installing the rear lane change warning sensor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Correctly position the lane change warning sensor (2) and shift in the arrow direction.
- Make sure that the detents are properly locked at the marked points.
- Insert and connect the connector (1).
NOTE:
TECHNICAL INFORMATION
For vehicles after the life cycle impulse, the absorber is to be retrofitted if the absorber was not yet installed. For vehicles before the life cycle impulse, only the version existing during the removal is to be taken into consideration.
For vehicles after the life cycle impulse, the absorber is to be retrofitted if the absorber was not yet installed. For vehicles before the life cycle impulse, only the version existing during the removal is to be taken into consideration.
- Position the absorber (1) and lock with the snap-in lugs (2).
- Make sure that the absorber (1) is correctly engaged with the snap-in lugs (2).
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL AT LEFT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to ADDITIONAL WORK AFTER THE INSTALLATION/REPLACEMENT .