66 31 115 Removing and installing front radar sensor long range (with holder)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Requirements for the measurement area for ACC adjustment device
Dimensions:
- Area behind the mirror of at least 80 cm that cane be entered
- Distance between mirror and vehicle 80 cm +/- 5 cm
(Distance between mirror and ACC sensor 100 cm +/- 5 cm)
- Total area of work area 360 cm x 660 cm
Maximum irregularity of floor surface:
- Floor surface - adjustment device ≤ 1 mm
- Floor surface - vehicle ≤ 10 mm
Maximum angle of inclination of floor surface - vehicle:
- Downward incline of floor surface maximum 3°, see graphic above (1)
- Upward incline of floor surface maximum 1°, see graphic above (2)
NOTE:
Setting up the ACC adjustment device (one-off task) comprises the following steps:
- Assembly of adjustment device
- Assembly of rail
- Basic setting of adjustment device on measurement area
Detailed setup and operating instructions are enclosed with every ACC adjustment device.
Preliminary work
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .