66 31 010 Adjusting the ACC sensor (M5 2018-2022)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Special tool required:
ACC adjustment device, complete.
Order number:0 442 898 .
Consisting of:
- Mirror, complete
- Wheel laser
- Slotted diaphragm
- Control holder (for initial installation of rail)
- Rail
- Setup and Operating Instructions (not shown)
NOTE:
A mounting which is not included in the scope of delivery is required to support the wheel laser. Use either the quick-action clamp from the existing Kinematics Diagnosis System or ACC wheel holder (2 338 466
).
NOTE:
- Follow notes for ACC ADJUSTMENT DEVICE .
NOTE:
To set the ACC sensor, connect the diagnostic system and fit the ACC adjustment device.
Make the setting in the following steps:
Handle ACC adjustment device in accordance with mounting and Owner's Manual provided with device.
Make the setting in the following steps:
- Service function
- Driver assistance
- ACC
- Start-up of ACC sensor
Handle ACC adjustment device in accordance with mounting and Owner's Manual provided with device.
NOTE:
Further information on the ACC adjustment device can be found in the applicable BMW applicable BMW Workshop Equipment and Planning documentation.
NOTE:
The following operation must be carried out if faulty code entry "Sensor misaligned" is present or is suspected to be present.
NOTE:
Illustration similar.
For purposes of clarity, graphic shows holder (1) removed.
For purposes of clarity, graphic shows holder (1) removed.
IMPORTANT:
The vehicle must be parked on a flat, horizontal
surface!
Hold square (2) against holder (1) as shown.
Limit stop leg length: approx. 105 mm
Check the vertical orientation in the direction of travel with a conventional bubble level (3).
If applicable, replace the bracket.
IMPORTANT:
After replacing the holder, check the ACC sensor position again using the square (2) and bubble level (3).
If the ACC sensor position is still not right, check the support for the bumper cover for damage and replace if necessary.
A damaged/bent holder (1) indicates a mechanical misuse of the vehicle and will not be considered to be a warranty case.
If the ACC sensor position is still not right, check the support for the bumper cover for damage and replace if necessary.
A damaged/bent holder (1) indicates a mechanical misuse of the vehicle and will not be considered to be a warranty case.