Installing The Left Luggage Compartment Floor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: WORKSHOP EQUIPMENT (BMW AND MINI VEHICLES) REP-ALG-RAGRP41-4101300 - V.12 (M5 2018-2022, M5 Competition 2019-2022, M5 CS 2022) .
Use only approved spot welder for repair.
For additional information see: WORKSHOP EQUIPMENT (BMW AND MINI VEHICLES) REP-ALG-RAGRP41-4101300 - V.12 (M5 2018-2022, M5 Competition 2019-2022, M5 CS 2022) .
- Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.CONSUMABLE DESCRIPTION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surfaces on vehicle and on new part with cleaning agent R1.CONSUMABLE DESCRIPTION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K5 to the bonding surfaces.ADHESIVE DESCRIPTION
Body adhesive K5 50 ml 83192158654 - Install the new part and rivet it in the area (1) with blind rivets N1.CONSUMABLE DESCRIPTION
Blind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm83190301414 - In the area (2), use a bind rivet N2.CONSUMABLE DESCRIPTION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (3).
- MAG weld the new part in the area (1). The weld seam has a length of 10 mm.
- Ensure sufficient distance to the bonded rivet connection (2).NOTE: To provide a better overview: Shown without side panel.
- Rivet the new part in area (2) with blind rivets N2.CONSUMABLE DESCRIPTION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (1). Avoid applying too much heat to the adjacent adhesive area (2).
- Weld the new part in the area (1).