Install the Front Light Electronics
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen screws (1).
- Pull the Frontal Light Electronics (2) out of the headlight.
- Unlock and disconnect connector (1).
- Remove the Front Light Electronics (2).
- Check the seal (3) on the Frontal Light Electronics (2) for damage and replace if necessary.
- Connect plug (1)
.
Check
- After locking: The plug connection must be checked for correct, firm fit.
Result
» The firm fit is not correct.
Measure
- Disconnect the connectors and check the locking mechanism for mechanical damage.
Measure
- Replace the damaged plug components.
Measure
- Fit, insert and lock the connector at a right angle to the direction of insertion.
Measure
- Check correct firm fit again.
- Position the front light electronics (2) in the headlight.
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Frontal Light Electronics (FLE) | ||
|---|---|---|
| PT-SCREW 40x12 | tightening torque | 1.5 Nm |