LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Suspension - Repair - E46) >> Adjustments >> Ride Height

Ride Height

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW 330xi, 2005 BMW 330i, and 2005 BMW 330Ci. However, it is still accessible from the selected car via links, so may be relevant.

Load each front seat with 150 lbs. Place 46 lbs. in trunk and ensure gas tank is full. To measure front ride height, see appropriate FRONT article. Measure rear ride height from lower edge of wheel arch to bottom edge of wheel rim. Determine average value of each wheel after lifting and lowering vehicle body and then average each axle. For correct ride height, see REAR RIDE HEIGHT SPECIFICATIONS  table. If ride height is not within specification or deviates more than 0.4" (10 mm) between wheels, coil springs must be replaced. Replacement spring can be determined from parts microfiche, parts supplier, or on old spring at one end.

REAR RIDE HEIGHT SPECIFICATIONS

Application In. (mm)
Standard Suspension
15" Rim 21.3 (542)
16" Rim 21.9 (555)
17" Rim 22.4 (570)
18" Rim 23.0 (583)
Low-Slung Sports Suspension
15" Rim 20.7 (526)
16" Rim 21.2 (539)
17" Rim 21.8 (554)
18" Rim 22.3 (567)
Rough Road Package
15" Rim 22.1 (562)
16" Rim 22.6 (575)
17" Rim 23.2 (590)
18" Rim 23.7 (603)