Removing the sealing sleeve for the transmission housing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING TRANSMISSION OIL PAN (ALL WHEEL DRIVE VEHICLE) (GA8HP75Z, GA8HP76Z) .
- Refer to REMOVING THE OIL VOLUME RESERVOIR (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z, GA8HP95Z) .
- Refer to REMOVING TRANSMISSION CROSS-MEMBER .
CAUTION:
Materials harmful to health
.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
- Turn the connector (1) in arrow direction and detach it.
- Do not touch pins.
- Release cable from holders.
- Insert the special tool 0 494 213 (24 2 390) in arrow direction in the sealing sleeve (1).
- Release the screw (1) and unlock the sealing sleeve with the slide (2).
- Observe the installation position of the sealing sleeve (1).
- Pull out the sealing sleeve (1) in arrow direction.