Installing the radial shaft seal for the selector shaft (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z, GA8HP75HZ, GA8HP95Z)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Oil the sealing lip of the radial shaft seal.
Drive the radial shaft seal to the stop using the special tool 0 494 208 (24 5 366) and a plastic hammer.

Courtesy of BMW OF NORTH AMERICA, INC.

Slide the selector shaft (1) into the housing in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Replace clamping sleeve (1).
Parts: Clamping sleeve
Insert the clamping sleeve (1) into the cylinder bore with the tapered side.
Use a suitable tool to hammer the clamping sleeve (1) until the clamping sleeve (1) is flush with the cylinder bore.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE MECHATRONICS .
Refer to INSTALLING TRANSMISSION OIL PAN (ALL-WHEEL DRIVE VEHICLE) (GA8HP75Z, GA8HP76Z) .
Refer to CONNECTING BATTERY GROUND LEAD .
Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING FRONT PROPELLER SHAFT AT THE FRONT AXLE TRANSMISSION .
Refer to INSTALLING THE TRANSFER BOX (ATC 13-1) .
Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
Refer to INSTALLING THE HEAT SHIELDS .
Refer to INSTALLING TRANSMISSION CROSS MEMBER .
Refer to INSTALLING EXHAUST SYSTEM .

Installing the rear tunnel connecting support.

Courtesy of BMW OF NORTH AMERICA, INC.

Position the connecting support (3) on the rear of the tunnel.

Tighten the screws (1).

TIGHTENING TORQUES

Rear connecting support tunnel to body
M8x30	Snug torque Angle of rotation	28Nm 90°

Tighten screws (2).

TIGHTENING TORQUES

Undershield
Hexagon screw	tightening torque	2.6Nm
Plastic nut	tightening torque	2.6Nm

Refer to INSTALLING THE REINFORCEMENT STRUT .
Refer to INSTALLING UNDERSHIELD ON THE FUEL TANK ON THE RIGHT .
Refer to INSTALLING THE UNDERSHIELD ON THE LEFT FUEL TANK .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to INSTALLING THE REAR DIFFUSER .