Installing the hydraulic valve for the oil pressure control

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Replace the O-ring (1) on the hydraulic valve for the oil pressure control (2).
Parts: O-ring
Coat the O-ring (1) with escaped engine oil.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the hydraulic valve for the oil pressure control (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Hydraulic valve for oil pressure control
M6x18 screw	Tightening torque	8.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Position heat shield (2).
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

heat shield
M6x16 screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to TOPPING UP MOTOR OIL .
Refer to CHECKING ENGINE OIL LEVEL .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING FRONT UNDERBODY PROTECTION .