Install the BDC control unit
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the connector of the positive battery cable (1) to the BDC control unit (4).
It is essential to observe the sequence:
- Install the positive battery cable connector (1) in the direction of the arrow.
- Check that retaining lug (2) is engaged correctly.
- Close lock (3) arrow direction.
- Guide in the BDC control unit (1).
- Connect all connectors (1) and lock.
- Guide in the BDC control unit (2) in the direction of the arrow.
- Connect all connectors (1) and lock.
- Insert cover (2) in arrow direction.
- Check the detents (1).
- Tighten screw (2) at cover (3).
TIGHTENING TORQUES SPECIFICATION
| Body Domain Controller (BDC) | ||
|---|---|---|
| Sheet metal screw 4.8x16 |
tightening torque | 1.2 Nm |
- Position the carpet (1).
Follow-up work
- Refer to INSTALLING SIDE TRIM PANEL IN FOOTWELL ON RIGHT A-PILLAR .
- Refer to INSTALLING THE FRONT DOOR SILL COVER STRIP .
- Refer to INSTALLING THE FOOTWELL TRIM PANEL ON THE RIGHT .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .