Installing wiring harness section for ignition system of bank 2
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in wiring harness section and position.
- Engage wiring harness section in holders (4).
- Engage wiring harness section with holder (1).
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to hold-down device | ||
| Nuts | Tightening torque | 5.5 Nm |
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Cable duct | ||
| M6x16 screw | Tightening torque | 10 Nm |
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to hold-down device | ||
| Nuts | Tightening torque | 5.5 Nm |
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Cable duct | ||
| M6x16 screw | Tightening torque | 10 Nm |
- Engage wiring harness section in marked areas (1).
Follow-up work
- Refer to CONNECTING THE CONNECTOR OF THE IGNITION COIL OF CYLINDER BANK 2 .
- Refer to CONNECTING THE CONNECTOR OF THE INJECTORS OF CYLINDER BANK 2 .
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to INSTALLING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING BATTERY GROUND LEAD .