Installing wiring harness section for ignition system of bank 1
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in ground cable and position.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to hold-down device | ||
| Nuts | Tightening torque | 5.5 Nm |
- Engage wiring harness section in holders (4).
- Engage wiring harness section with holders (1).
- Tighten screws (2).
TIGHTENING TORQUES SPECIFICATION
| Cable duct | ||
| M6x16 screw | Tightening torque | 10 Nm |
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to hold-down device | ||
| Nuts | Tightening torque | 5.5 Nm |
Follow-up work
- Refer to ATTACHING CONNECTOR OF THE IGNITION COIL OF CYLINDER BANK 1 .
- Refer to ATTACHING CONNECTOR OF THE INJECTORS OF CYLINDER BANK 1 .
- Refer to INSTALLING (PARTIAL INSTALLATION) THE EXPANSION TANK FOR THE CHARGE AIR COOLERS .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING ACOUSTIC COVER .
- Installing the cover panel of the master DME control unit.
- Position the cover of the master DME control unit (1)
- Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
- Refer to CONNECTING BATTERY GROUND LEAD .