Install EMF actuator

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

EMF actuator (1) Carefully fit controller drive until gearing engage and EMF actuator rests flush on brake caliper.
If necessary, turn the EMF actuator slightly until the bore and the screw thread are aligned.

Courtesy of BMW OF NORTH AMERICA, INC.

Attach the holder (4) and position and tighten the bolts (3).

TIGHTENING TORQUES SPECIFICATION

EMF actuator to brake caliper
Replace screws.	tightening torque	12 Nm

Connect plug (1).
Attach the brake hose (2) in the holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to AFTER EMF ACTUATOR REPLACEMENT: PUTTING ELECTROMECHANICAL HOLDING BRAKE INTO OPERATION .