Remount the holder of the hydraulic unit and remount the brake lines
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Remount hydraulic unit holder
- Release screws (1) and remove the holder (2).
- Install holder (2).
- Insert screws (1) and tighten them.
TIGHTENING TORQUES SPECIFICATION
| Hydraulic control unit to holder | |
| M6 Replace screws. | 8 Nm |
Remount brake lines at the hydraulic unit
- Release all brake lines (1) and completely remove with the holders.
- Fit all brake lines (1) completely with the holders.
- Tighten all brake lines (1).
TIGHTENING TORQUES SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |