Remounting the EMF actuator
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Release screws (3) and remove the holder (4) .
- Remove the EMF actuator (1) in the direction of the arrow from the brake caliper.
- EMF actuator (1) Carefully fit controller drive until gearing engage and EMF actuator rests flush on brake caliper.
- If necessary, turn the EMF actuator slightly until the bore and the screw thread are aligned.
- Attach the holder (4) and position and tighten the bolts (3) .
TIGHTENING TORQUES SPECIFICATION
| EMF actuator to brake caliper | ||
| Replace screws. | tightening torque | 12 Nm |
- Fit and tighten brake hose (2) on brake caliper.
TIGHTENING TORQUES SPECIFICATION
| Brake hose to brake caliper, rear | ||
| tightening torque | 24 Nm | |
- Hook the brake hose into the holder (1) .