Initialize component protection
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
After replacement of the BDC or the head unit or after installation of a used head unit, the component protection must be reinitialized.
After replacement of the BDC or the head unit or after installation of a used head unit, the component protection must be reinitialized.
- During replacement
of BDC or the head unit, reinitialize the component protection with the diagnostic system as follows:
- The BDC or the head unit under: Mark "Vehicle management/control unit exchange/after the exchange" as exchanged.
- Determine the action plan and execute.
- You must follow the instructions!
- When installing a used head unit
, reinitialize as follows:
- contact Technical Support
- Then, reinitialize the component protection in workshop system
via immediate measure
"Initialization of component protection of head unit (HU)" in the "Additional software" tab.
- You must follow the instructions!