Detaching the wiring harness of the EPS from the front axle support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
Version A: Loosen wiring harness
- Unlock and disconnect plug connections (1) .
- Release the wiring harness in the areas (2) from the front subframe.
- Release the wiring harness in the areas (3) .
- Place wiring harness to one side.
Version B: Loosen wiring harness
- Unlock and disconnect plug connections (1) .
- Release the wiring harness from the front axle support in the areas (2) .
- Loosen the wiring harness (3)
from the retaining bracket.
- Release the wiring harness (1) in the areas (2) .
- Set wiring harness (1) aside.