Connecting the connectors on left and right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Connect connector
- Connect connectors (3) and lock.
- Secure the lines (2) in the holders.
- Close and lock the lid (1)
.
- Position wheel arch trim panel (2) .
- Tighten nut (1) .
TIGHTENING TORQUES SPECIFICATION
| Wheel arch cover | ||
| screw | Tightening torque | 3 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |