Remove coil spring
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to REMOVING FRONT LEFT OR RIGHT WHEEL .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE REAR LEFT OR RIGHT .
- Refer to REMOVING THE SIDE HOOD SEAL ON THE LEFT OR RIGHT .
- Refer to PARTIALLY DETACHING SPRING STRUT IN FRONT .
- Refer to RELEASING THE UPPER WISHBONE FROM THE SWIVEL BEARING .
- Refer to SECURING THE SWIVEL BEARING .
- Refer to REMOVING THE SPRING STRUT HOLDER .
- Refer to REMOVING FRONT SPRING STRUT .
NOTE:
RISK OF DAMAGE
Damage of the coil spring .
Any use of faulty protective inserts leads to coil spring damage. Faulty protective inserts may lead to a cracked coil spring (corrosion) .
Damage of the coil spring .
Any use of faulty protective inserts leads to coil spring damage. Faulty protective inserts may lead to a cracked coil spring (corrosion) .
- Check the protective insert for wear or damage and if necessary, replace the protective inserts.
- Clamp special tool 0 493 556 (31 3 341) in vice.
- Attach the special tool 2 318 833 from the top to the special tool 0 493 556 (31 3 341) until you can her and feel the retaining bolts engage.
- Check position of the special tool 2 318 833 and correct if necessary.
Prepare pressure plates
- Mount the special tool 2 359 293 to the special tool 2 318 833 .
Prepare special tool 2 318 833 2 x and always use with the protective insert!
- Set special tool 0 493 556 (31 3 341) to dimension A.
Dimension A = 140 mm
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Clean coil spring to remove heavy contamination.
- Attach the spring strut (1) to the coil spring with the special tool 2 318 833 .
- Make sure that the coils of the coil spring are completely placed into the recesses of the special tool 2 318 833 .
- Tension the coil spring until dimension (B) is reached at the special tool 0 493 556 (31 3 341) .
Dimension B =95 mm
It is essential to ensure that the dimension does not fall below dimension (B).
Remove the spring strut support bearing
NOTE:
TECHNICAL INFORMATION
Releasing and tightening the nut on the support bearing or spring strut support bearing with an impact screwdriver is prohibited.
Releasing and tightening the nut on the support bearing or spring strut support bearing with an impact screwdriver is prohibited.
- Release the nut (1) with the special tool 2 360 213 , reversible ratchet with extension and socket SW10.
- Remove the spring strut support bearing (2) with the spring pad.
- Remove the spring strut (1) with the auxiliary damper, the protective tube and the spring pad from the tensioned coil spring (2).
- Relieve tension on special tool 0 493 556 (31 3 341) .
- Remove the coil spring (1) from the special tool 2 318 833 .