Installing the front axle support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Release the screws (1) on the engine oil cooler (2) at left and right.
- Position the front subframe (2) below the vehicle.
- Position engine oil cooler (1) behind the front axle support (2) .
- Lift the front subframe (1) with the special tool 0 490 133 (00 2 030) in arrow direction and position it on the vehicle.
- Release the tensioning strap (2) .
- Position engine oil cooler (2) .
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| upstream engine oil cooler | ||
| M6x45 screw | Tightening torque | 8 Nm |