Securing upper wishbone, right, at the swivel bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Fastening the wishbone to the top of the swivel bearing
- Position the wishbone pin (4) in the bore of the swivel bearing (3) .
- Replace the screw (2)
and the nut (1)
.
Parts: Screw, nut
- Install the bolt (2) .
- Tighten the screw connection using the nut (1) .
TIGHTENING TORQUES SPECIFICATION
| Upper wishbone to swivel bearing | ||
| M10 Replace screw and nut. Tightening via nut. |
Tightening torque | 56 Nm |