Secure the juncture shaft in front on the front axle differential

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Before installing the prop shaft on the front axle transmission, all 4 threads (1) in the front axle transmission flange must be freed of possible residue and contaminations and cleaned.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws.
Parts: Screws

A drop of Loctite 270 (2) must be given before the screw connection on each thread at the end of the respective screw (1) .

CONSUMABLE SPECIFICATION

High-strength screw lock, Loctite 270

10 ml, Tube

83 19 2 210 337

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
After the screw connection of the front prop shaft, a 30 minute hardening time must be ensured before the vehicle is operated again.

Position the propeller shaft in front on the front axle differential.
Replace the bolts (arrows).
Parts: Screws
Tighten screws (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Prop shaft before the front axle differential
Replace screws. Joining torque and angle of rotation must be observed without fail.	Tightening torque	25 Nm
	Angle of rotation	45°